Category Archives: Uncategorized

Oil pressure and oil temp sensor

Posted on October 22, 2018 by

 Check engine light came on a N20  saying engine temperature faulty,,,,checked connection ok,,,the sensor is located under the intake manifold you remove the intake pipe and throttle housing to gain access.  Here is the old and new sensor,,,this sensor does oil … Continue reading →

Posted in Uncategorized | Tagged , | Leave a comment

blower motor wiring recall

Posted on October 19, 2018 by

 This is pretty bad,,,this is burnt and damaged blower motor harness,,,,this what we see while repairing the blower motor harness for the recalled,,,usually we just see the harness slightly burnt,,,we don’t see the harness completely damaged. This is the brown ground … Continue reading →

Posted in Uncategorized | Tagged , , | 1 Comment

E38 with S62 engine

Posted on July 18, 2018 by

 Yes your eye sight is ok,,,,this is a E38 with a S62 engine installed,,,this engine swap looks factory from top and bottom also the 6 speed trans is installed. I was called in on this car,,,,the customer is having a hard … Continue reading →

Posted in Uncategorized | Tagged , | 12 Comments

ZF 8 speed transmission

Posted on July 12, 2018 by

    Here are some picture of a transmission leak on a ZF 8 speed which is very rare,,,,we don’t see this to offen anymore not like the older transmission where the mechtronic sleeve would leak all the time. So what I … Continue reading →

Posted in Uncategorized | Tagged , | 14 Comments

B48 starter motor

Posted on July 6, 2018 by

 Here the location of the starter motor on the new B48 engine,,,,,this is as easy as it comes,,,,this is located at the very bottom of the engine,,,,all you have is 3 bolts holding in place and only 2 cables to … Continue reading →

Posted in Uncategorized | Tagged , | 3 Comments

F15 X5 PHEV electric auxiliary heater

Posted on May 17, 2018 by

 Ok here’s the first for me,,,check engine light on a 2016 F15 X5 PHEV,,,,the fault was electric auxiliary heater internal fault detected,,,performed the normal test operation. This is a pretty basic unit you have water in and water out,,,,you have a … Continue reading →

Posted in Uncategorized | Tagged , , | 2 Comments

Tow hook

Posted on May 17, 2018 by

 Ok here the tow hook we modify so we can use it for the engine hook,,,,you grind down the lip so it can screw all the way in to the cylinder head next to the oil filter housing on the … Continue reading →

Posted in Uncategorized | Leave a comment